First Connection

Step 1: Two ways to start connecting the LOKLiK iEngrave™

1. 1.1 Tap "+" icon to add new device;

   

2. 1.2 Go to "Canvas" and tap "Make" directly. Then the app will prompt "Unconnected Device" and tap "Connect Device" to start the connection.

   

Step 2: Select your LOKLiK iEngrave™

Step 3: Go to "Add Device" page

• Remember your laser WiFi name and password and tap "Connect to Laser Engraver WiFi";

  

• Turn on the WLAN and use the password to connect to your laser WiFi;

  • Note: Please turn on your laser and ensure it can be used normally.
  • If your phone failed to detect laser WiFi, please refer to "Unable to Find Device Hotspot (for devices already configured to a network)" for guidance.

• Waiting for the laser to establish communication with the phone.

  

• When setting up STA mode, select your home WiFi and tap the "Connect" icon to connect the laser to the home WiFi.

  

Step 4: Connection Success

• If the configuration succeeds, the laser will make a beep sound. You will see the connected laser in the "My Device" module. Now you are ready for engraving.

  

• Note: If the connection fails, make sure the laser isn't being used by another device and is functioning properly. Restart the device and try connecting again.